Foaming

ASTM D892 (I, II , III ) IP 146 ISO 6247 DIN 51566 FOAMING CHARACTERISTICS OF LUBRICATING OILS
This test method covers the determination of the foaming characteristics of lubricating oils at 24°C (75.2°F) and 93.5°C (200.3°F). Means of empirically rating the foaming tendency and the stability of the foam are described.

ASTM D6082 (IV ) HIGH TEMPERATURE FOAMING CHARACTERISTICS OF LUBRICATING OILS
This test method describes the procedure for determining the foaming characteristics of lubricating oils (specifically transmission fluid and motor oil) at 150°C (302°F).

FOAMING BATH (2 POSITIONS)
Foaming Bath (2 positions)

Consists of a tank fitted with cover with two hole, Ø125 mm (4.92 in.), which allows two cylinders to get through, and a cooling coil, leakage protection vessel made of tempered glass supplied with two cork disk supporting. Stainless steel control box on the cover, temperature controlled by digital thermoregulator PID with PT100 probe class A and overtemperature alarm, stainless steel heater, cooling coil for improved control near to ambient temperature, motor stirrer, safety internal level for low liquid with warning lamp. Plate base painted with anti-acid epoxidy products which houses two indipendents blowing pumps connected to two flowmeters. Complete with: 2x flowmeters, 2x graduated cylinders, 2x diffuser ball-shape, 2x rubber plug and diffuser tubes.

Technical specifications:
– Temperature: from ambient to +150°C (302°F)
– Stability: ±0.1°C
– Capacity: about 23 l
– Power supply: 220V 50/60Hz
– Power: 2200 W

 

FOAMING BATH (4 POSITIONS)

Consists of two tanks, one for working 24°C (75.2°F) and one for working up to 150°C (302°F), fitted with cover with two hole, Ø125 mm (4.92 in.), which allows two cylinders to get through, and a cooling coil, leakage protection vessel made of tempered glass supplied with two cork disk supporting. Stainless steel control box on the cover, temperature controlled by digital thermoregulator PID with PT100 probe class A and overtemperature alarm, stainless steel heater, cooling coil for improved control near to ambient temperature, motor stirrer, safety internal level for low liquid with warning lamp. Plate base painted with anti-acid epoxidy products which houses four indipendents blowing pumps connected to four flowmeters. Complete with: 4x flowmeters, 4x graduated cylinders, 4x diffuser ball-shape, 4x rubber plug and diffuser tubes.

Technical specifications:
– Temperature: from ambient to +150°C (302°F)
– Stability: ±0.1°C
– Capacity: about 23+23 l
– Power supply: 220V 50/60Hz
– Power: 1200+2200 W