Oxidation Stability – RPVOT (RBOT) / TFOUT

ASTM D2112 OXIDATION STABILITY OF INHIBITED MINERAL INSULATING OIL BY PRESSURE VESSEL
This test method covers and is intended as a rapid method for the evaluation of the oxidation stability of new mineral insulating oils containing a synthetic oxidation inhibitor. This test is considered of value in checking the oxidation stability of new mineral insulating oils containing 2,6-ditertiary-butyl para-cresol or 2,6-ditertiary-butyl phenol, or both, in order to control the continuity of this property from shipment to shipment. The applicability of this procedure for use with inhibited mineral insulating oils of more than 12 cSt at 40°C (104°F) (approximately 65 SUS at 100F) has not been established.

ASTM D2272 OXIDATION STABILITY OF STEAM TURBINE OILS BY ROTATING PRESSURE VESSEL
This test method utilizes an oxygen-pressured vessel to evaluate the oxidation stability of new and in-service turbine oils having the same composition (base stock and additives) in the presence of water and a copper catalyst coil at 150°C (302°F).

ASTM D4842 OXIDATION STABILITY OF GASOLINE AUTOMOTIVE ENGINE OILS BY THIN-FILM OXYGEN UP TAKE (TFOUT )
This test method evaluates the oxidation stability of engine oils for gasoline automotive engines. This test, run at 160°C (320°F), utilizes a high pressure reactor pressurized with oxygen along with a metal catalyst package, a fuel catalyst, and water in a partial simulation of the conditions to which an oil may be subjected in a gasoline combustion engine. This test method can be used for engine oils with viscosity in the range from 4 mm2/s (cSt) to 21 mm2/s (cSt) at 100°C (212°F), including re-refined oils.

ASTM D7098 OXIDATION STABILITY OF LUBRICANTS BY THIN-FILM OXYGEN UP TAKE (TFOUT) CATALYST B

IP 229 DETERMINATION OF THE RELATIVE OXIDATION STABILITY BY ROTATING BOMB OF MINERAL TURBINE OIL
This standard specifies a method for the estimation of the oxidation stability of unused turbine oils having the same composition (base stock and additives) and for controlling the continuity of this property from batch to batch.

Available in two versions both two positions, bench version and floor version.
External frame painted with epoxy acid-proof stainless steel tank stainless 70 liters about where the oxidation vessels are turned at 100rpm with a 30° angle according to ASTM specifications.
The temperature control is a thermoregulator PID with PT100 probe class A and overtemperature alarm, stainless steel heater, cooling coil, motor stirrer, insulated double wall, safety internal level for low liquid with warning lamp.

Technical specifications:
– Temperature: from ambient to 180°C (356°F)
– Stability: ±0.1°C
– Capacity: 70 liters about
– Power supply: 220V 50Hz
– Power: 3200W

RPVOT BATH (RBOT)/TFOUT
Bench model
Technical specifications:
– Dimensions: 90x60x70 cm
– Weight: 85 kg

RPVOT BATH (RBOT)/TFOUT
Floor model
Technical specifications:
– Dimensions: 90x60x120 cm
– Weight: 105 kg